12/7/2023 0 Comments Wooden lattice hanger![]() Mark the measurements on the lattice with a chalk line, and then carefully cut it to the desired dimensions. Having the plywood to cut into will keep the lattice from "chattering." Because lattice is built from sections of small lathes in a criss-cross section, it will bounce when it is cut if not on a stable surface. Adjust the blade so that the blade will be 1/4 inch below the lattice. Set the lattice work on top of the plywood. You are going to cut into this too, so it will be wise to use an old piece or a few pieces of scrap put together. Set a piece of plywood either on a stable surface or on sawhorses. The most efficient way is to cut the lattice with a circular saw. ![]() There are several different ways to cut lattice. The wing is of medium - thickness chord profile, fabric covered, orthodox wooden construction, with box spars and lattice ribs made of Spanish. When you go to install the lattice work, you will see that this will give it a nice finish look. Measure the lattice from the outer edges of the vertical boards and the inside edges of the horizontal boards. Lattice comes in two size sheets: two feet by four feet and four feet by four feet. Step 2 - Take Measurements for LatticeĪfter the frames are built for the lattice work to be installed on, you can take the actual measurements for the lattice. When a frame is not used, you will be trying to work with the contour of the ground. This frame acts as a guide for your measurements so that you always have a straight edge to measure against.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |